EasyManuals Logo

LifeSpan SPRINTER XL User Manual

LifeSpan SPRINTER XL
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
We recommend you use a silicone based spray to lubricate your Lifespan
Treadmill. This Can be purchased from your local sports Retailer or a local
hardware store.
4.5 Belt Adjustment
Belt Tension Adjustment-It is very important for joggers and runners in order to
provide a smooth, steady running surface. Adjustment must be made from the right and
left rear roller in order to adjust tension with the Allen Key provided in the parts package.
The adjustment bolt is located at the end of the rails as noted in diagram below:
Left bolt Right bolt
Note: Adjustment is thru small hold of end cap.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the
right and left bolt clockwise one full turn and inspect for proper tension. When an
adjustment is made to the belt tension, you must also make a tracking adjustment to
compensate for the change in belt tension.
DO NOT OVER TIGHTEN - Over tightening will cause belt damage and premature bearing
failure. This may also cause reduced motor performance and excessive roller wear.
NOTE: When properly tightened, the sides of belt can be raised approximate 2-3 inches off
the board.
LIFESPAN SPRINTER Page18

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LifeSpan SPRINTER XL and is the answer not in the manual?

LifeSpan SPRINTER XL Specifications

General IconGeneral
BrandLifeSpan
ModelSPRINTER XL
CategoryTreadmill
LanguageEnglish

Related product manuals