To Next Page

To Previous Page

Step 3: Upright Post Cover

Attachment

A. Remove pre-installed M4x8L

screw (13).

B. Install the left upright cover (4)

by sliding the front of the cover

around the upright and centering

or aligning the cover on the

upright.

C. Install the M4 x 8L screw (13).

D. Repeat steps A and B for the right

upright cover.

Step 4: Handlebar Attachment

A. Place the M8 x 100L bolt (11)

and M8 washer (12) through

the left handlebar and into

the uprights being careful not

to damage any wires running

through the handlebar. Repeat

for the right handlebar.

B. Loosely thread both bolts into

the upright prior to tightening.

C. Fully tighten both handlebar

attachment bolts.

Assembling Your Treadmill

5mm Allen

Wrench w/

Phillips

M4 x 8L

(x2)

M8 x 100L

(x2)

M8 Washer

(x2)

6mm Allen

Wrench

LifeSpan TR5500iM User Manual

Questions and Answers: