6. USER DEFINED PROGRAM
There are three program U1, U2, U3 for user defined.
User define program setting
Press “PROGRAM” continuously under standby mode until window display U1-U3, press “MODE” to start
setting first segment, setup speed and incline by pressing “SPEED+”“SPEED-”AND
“INCLINE+”“INCLINE-”, press “MODE” finish first segment setting and enter second one, until finish
all 20 segments. The data will be permanently saved until user reset next time.
Start user define program
A. Press “PROG” under standby mode until window display U01-U03, press START after setting
running time for this program.
B. Press START bottom after setting user define program and running time.
Instruction of user define program setting
Each program is divided into 20 segments, the machine can only be started when all the speed and
incline are finish set for each segment.
7. BODY FAT TEST
Press ‘PROGRAM’ button under ready condition, till ‘FAT’ show in the window. ‘FAT’ is body fat test mode. Press
‘ MODE’ to choose parameter ‘ SEX / AGE / HEIGHT / WEIGHT’, and the window will show “F-1”，“F-2”、“F-
3”“F-4". When set each parameter, press SPEED or INCLINE bottom to adjust the data, and the window will
show the data and press ‘MODE’ button to finish, and the window will show“-5-” and“---” enter into ready
condition. Hold the handle pulse with two hands, it will show your BMI data after 5 seconds. (Below date just for
reference)
Data display and set range
To Next Page
Loading...
Need help?
General
