Lifetime 1270 - Step 1.4: Join Middle and Bottom Poles

15
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
Align the hole in the -IDDLE0OLE!,& with the slot in the Bottom Pole (ALE) and
slide the Middle Pole over the Bottom Pole. Insert a vXv3CREW!$3
through the $OMED#OUNTERSINK7ASHER#)( and the small hole in the Middle
Pole and into the slot in the Bottom Pole as shown.
SEC

ADS (x1)
Note: The 1/4” x 3/4” Screw should be fl ush with the Pole, but will spin
freely once installed. Do not jam the Poles together until instructed.
!
ALE
ADS
ALE
!,&
!,&
CIH