13
Cleaning and Care
Lifetime
®
watercraft are stain- and solvent-resistant. Most stains can be removed, using a
mild soap and a soft-bristled brush. Abrasive cleaning materials may scratch the plastic
and are not recommended. Avoid placing a direct heat source on or near surfaces.
• Clean and check the board as well as all accessories before each use
• Make sure the board is completely dry before putting it away.
• Make sure no sand or gravel remains inside the board or between the hull and the inner
chambers. This could result in abrasion or even punctures while storing the board.
• Roll it up from the opposite end of the valves so remaining air can escape from the valves.
Helpful Tips
• Cleaning the hull with mild soap and water is recommended periodically to keep your
watercraft looking new.
• Always store your paddleboard out of direct sunlight when not in use.
• If your watercraft has been exposed to hot sunlight, it is recommended to splash water on
the hull to cool the hot surface before it comes in direct contact with your skin.
• Never drag any portion of the paddleboard over asphalt or any rocky, sandy or abrasive
surface.
• Do not stand or sit on your watercraft when out of the water. This can damage the hull.
• After each use, defl ate the paddleboard. Allow time for it to air out and dry completely to
prevent mildew and foul odor.
• When storing your infl atable paddleboard, keep it in clean, dry place.
MAINTENANCE
Congratulations on your Lifetime
®
Products purchase. By following the instructions below,
your new Lifetime paddleboard should provide you with years of service and enjoyment.
To Next Page
Loading...
