7
• Before performing any repairs, make sure the Paddleboard is fully deflated and
lies flat.
1. Prepare a round patch no less than 3 inches or 7 cm in diameter.
2. Clean the patch and the area surrounding the leak with alcohol.
3. To contain excess glue, use masking tape to tape off the area around the patch.
4. Apply 3 thin, even coats of repair kit adhesive to both the surface of the board
and the patch. Wait 5 minutes between each coat.
5. After the third coat, wait 10-15 minutes before applying the patch. Make sure to
apply the patch evenly. Pay special attention to the edges.
6. Wait 24 hours before reinflating.
REPAIR KIT
4
• If an additional repair kit is needed,
contact our Customer Service
Department (see front cover).
!
• In the unlikely event there is an
issue with the valve, the valve
wrench can be used to carefully
remove and retighten the valve.
!
To Next Page
Loading...
