-23-
◎ Please check whether the DMX512 controller pass the “turn on”oder.
◎ Please check the connection of the trigger circuit is loose contact.
◎ Please check whether the connected point of he trigger point is loose contact,faster the
connect cable.
◎ Check menu “information”→fan speed/voltag→fan1,fan2,fan3”，Whether the fan speed
in 500RPM above,below 500RPM the lamp does not light, replace with the specifications of
the fan.
◎ Please check if the switch of the temperature is damaged.
◎ Enter the menu “information”select “temperature”to see whether the temperature display
boad is too high or no temperature display.
■ The light beam dark, not inhomogeneou.
◎ when the lamp is to the usage life ,the light is not enough,please change a new one for
the same description.
◎ Please check the reflector parts is dirty.Keep them clear.
◎ Please measure if the power supply is enough.
◎ Small adjusting is suitable for change height or screw systen till get a ideal light beam.
◎ Enter the menu“service options”to choose “calibration”to enter the “Color” and“Gobo”
adjustment,the center can be modulated.
■ The light shadow is fogging
◎ Please check the data on the DMX 512 controller is suitable for the electric focus.
◎ Please check the machenical parts is jamging.After cleaning,please add some
temperature -durable juice.
■ The light works interruptly
◎ Please check if the fan works normally or mote clogging.
◎ Please check whether the abstract heat have the mote clogging.
◎ Please check if the lamp is to the usage life.
◎ Please check if the power supply is enough,the connection of the power supply or the circuit are
good.
◎ Please check if the switch of the sup-temperature is good.
To Next Page
