Lighthouse REMOTE 2014P, 3014P, 5014P Operating Manual
3-8 248083408-1 Rev 1
Remote Display Connector
An optional REMOTE Display touchscreen can be connected to the
2014P, 3014P or 5014P instrument. This display is a color touchscreen
interface. A longer cable can be attached to the Display so that the
instrument can be running in a clean area while the Display is mounted
on a wall bracket in a different area.
Please refer to the REMOTE Display Operating Manual for details.
Peripheral Interface Connector
An external peripheral device such as a light stick, buzzer or remote
control device can be connected to the back or the REMOTE P via the
Peripheral Interface Connector (PIC) .
The connector has the following pin-outs.
USB Communications
The REMOTE P provides point-to-point communications via the USB
Port.
If it hasn’t been done, yet, install the USB driver provided on the
product CD. Once it has been installed and the instrument is connected,
the driver will be used to establish communications using a virtual
COM port on the PC.
Table 3-2 PIC Connector Pin-Outs
Pin Connection
1 24 VDC
2GND
3Alarm+
4Alarm-
5 Start/Stop
6 Not Connected
7 Not Connected
8GND
To Next Page
Loading...
