00
248083408-1 Rev 1 4-1
4 Programming
General
Information
The REMOTE 2014P, 3014P or 5014P can be programmed using the
MODBUS Protocol or by using the optional REMOTE Display. The
full MODBUS protocol is detailed in Appendix A.
This chapter contains the information needed to program the basic
configuration for the instrument to meet your needs.
DIP Switches The DIP switches are behind the cover plate illustrated below:
Figure 4-1 Panel Covering the DIP Switches
Remove the two Phillips head screws to expose the DIP switches.
Figure 4-2 Panel Removed, Switches Exposed
To Next Page
Loading...
