10
Connecting Devices with Bluetooth Wireless Technology
Bluetooth LED continually ashes red and
blue. This indicates the Sierra pairing mode
setting and lasts about two minutes. If this
step takes longer and the Bluetooth LED is no
longer alternating red and blue, start over
from step one.
3. With Sierra in pairing mode, follow the
menu prompts on your Bluetooth wireless
technology enabled device directing it to look
for Bluetooth wireless technology devices.
4. Select Lightspeed-V### (numbers may vary)
on your Bluetooth wireless technology
enabled device from the list of found devices.
5. If asked to enter a password or PIN, enter 0000.
Connecting devices with Bluetooth wireless
technology for the rst time
Before using a cell phone or other Bluetooth
wireless technology enabled device for the
rst time with Sierra, it must be “paired” or
electronically connected.
To pair a Bluetooth wireless technology enabled
cell phone with Sierra:
1. Turn on the headset and verify the green
LED is ashing. Make sure Sierra’s Bluetooth
mode is turned o. Blue or red ashes from
the Bluetooth LED should not be present (see
“Bluetooth Mode—ON and OFF”, page 11).
2. Press and hold the Sierra Bluetooth button
for about ve to ten seconds or until the
To Next Page
Loading...
