With both Lil Buddy components in place, take some time to visually check everything is
correct. This is the time to make any final adjustments and corrections to ensure a
straight-forward replacement.
• Make sure the two units are positioned correctly on the glass.
• Ensure the red line on the pump of each unit is not showing. If it is, the cup is not
totally secure on the glass. To rectify it, push the pump a few times, rapidly, unit the red
line is no longer in view.
• Ensure you have placed some tape or retention strips either side of the vehicle roof.
These will be used to prevent slippage once the new windshield has been fitted.
Final Checks
Visually check cup seals before setting
windshield into place. A red line showing
on the cups brass pump rod indicates a
bad seal. DO NOT use the Lil-Buddy with
a bad seal.
December 2008 Final Checks | 11
To Next Page
Loading...