disk. Insert the USB flash disk to the device, the User Log is saved to the device
automatically at the first time. the power indicator will flash when User Log is saved,
stop flashing when saved completely.
Default: User1
If the User Log is not loaded for the first time, the device will pop up a prompt
message, please choose whether to update or not.
Note! Naming the User Log as User1-User6, after saved the LUT table through the
USB flash disk, please power off, unplug it and restart the device.
3.2.4 Display
- Scan
Adjust the scan mode among [Aspect], [Pixel To Pixel], [Zoom].
Adjust the scan zoom mode among [User], [10%~90%].
- Aspect
Select the aspect of the image among [16:9], [1.85:1], [2.35:1], [4:3], [3:2], [1.33X],
[1.5X], [2.0X], [2.0XMAG].
To Next Page
Loading...
Need help?
General
