7 Maintenenance Schedule
Maintenance at Limbach aircraft engines is to be performed after fixed time periods or when
reaching a certain interval of operating hours. In addition, a "daily check" has to be performed
before each flight.
Repair activities during engine maintenance may only be performed by authorized persons.
7.1 Daily Check
Remove engine cowling.
Check bolted connections.
Check baffle assembly.
Check harness.
Check condition of drive belt.
Check cowling for cracks and correct attachment.
Check clearance of throttle pushrods and bowden cables.
Check engine oil level and refill as necessary.
Volume difference between max. and min. markings: 1 l.
Check oil and fuel system for leakage.
Perform test run (see section 8.20).
7.2 Periodical Checks
7.2.1 Every 6 Months Following 100 h Inspection
Check carburetor diaphragm of the Stromberg-Zenith carburetor for brittleness, strain or
cracks and replace, if necessary.
7.2.2 Every 2 Years after the last Overhaul
Disassemble and check magneto and replace as necessary (SLICK Magnetos only).
7.2.3 Every 5 Years after New or Main Overhaul
Replace oil and fuel hoses (mounted to the engine).
The oil and fuel hoses mounted to the engine are signed with a lapse date,
e.g. 5.15 - i.e. to be replaced not later than May 2015.
To Next Page
Loading...
