Linak DL12

Page 11 of 36
Description of the DESKLINE
®
system
Each DESKLINE
®
actuator/column is equipped with a motor and parallel/memory drive is ensured by means of software in the
CBD6S (SMPS) that also takes account of an oblique load on the desk. Soft start and stop are also part of this software, which
ensures a soft start and stop when adjusting the desk.
Application of the DESKLINE
®
system:
Irrespective of the load, the duty cycle 10% ~ 6 min./ hour or max. 2 min. at continuous use stated in the data sheets,
must NOT be exceeded as this will result in a superheating of the motor and the control box. Exceeding the duty cycle will
result in a dramatic reduction of the life of the system.
The DB/DL system range contains following products:
• 1 control box CBD6S 200W or CBD6S 300W (SMPS - Switch Mode Power Supply)
• DL12, DL14, DB14 or DL17 (1 - 4)
• 1 exchangeable mains cable
• Motor cables (1 - 4)
• 1 DP1U/DPF1M (if memory function is required) 1 DP1C//DPT/DPF1C (if memory function and display are required) or
1 DPA/DPB/DP1K/DP1V/DPFK (if only up/down is required) or DPF1D (if display is required)