Operation of the DPF1C “one reference”
Up and down (
V):
Just activate either the up or down button for parallel drive and the system will drive until the button is released again or the
system reaches end position.
Memory:
The four small buttons are used for memory drive/storing memory.
Store memory
• Press S – button, the display will flash for 2 seconds
• Within these two seconds press one of the small buttons with dots and the position will be stored at this button.
• The panel will acknowledge by showing “1”, “2” or “3” in the display depending on chosen position
Memory drive (small buttons with dots)
Press one of the memory buttons and the system will start driving to the pre-programmed memory position.
Keep the button pressed until the position is reached.
Display function
Shows the actual height in either cm or inch.
= Parallel up
V = Parallel down
S = Store memory
• = Memory 1
•• = Memory 2
••• = Memory 3
V
V
To Next Page
Loading...
Need help?
General
