Page 26 of 44
For safety reasons the DPT has a locking function.
If the DPT is locked, only a bar is lightning in the display. To unlock the control press ¨S¨ for 1 sec. When the DPT is
unlocked, the height will be shown in the display. Now the DPT is active for 2.5 seconds. When pressing one of the
keys you can do your adjustment. Hereafter the DPT will be active for 5 seconds but when there are no activations
made within the mentioned time slot, the DPT will go in to locking mode again. Also, if you press ¨S¨ for unlocking too
long, the DPT will unlock but immediately lock again.
The Touch Desk Panel is used to operate the DESKLINE
®
systems. The DPT is divided into parallel and memory drive. The two
arrow buttons are used for parallel drive and the last four buttons for memory drive.
Normal operation:
To run the desk up or down, press the or button, and keep it pressed until the desk reaches the desired height.
The display will count the height as the table is moving and will continually show the height of the desk after stopping.
Storing a memory position:
Touch the “S” button and the display will flash “S” for 3 sec. While the ¨S¨ is displayed, touch the memory button 1, 2 or 3.
The display will acknowledge by showing S1, S2 or S3 for 1 sec.
To abort a store sequence press the or button while the “S” is flashing, or wait the 3 seconds until the display
automatically returns to show the height of the desk.
Drive to a stored position:
Press memory button 1, 2 or 3 and the system will start driving to the desired memory position. Keep the button activated until
the position is reached. The display will count the height as it is driving to the memory position.
Customising the DPT digital display
Adjust the display to show the correct height:
The DPT will show 68 cm or 24.5 inches as the height of the desk as the default setting. It may be necessary to adjust the
displayed height due to different thicknesses of desktops etc. when the DPT is delivered from the factory. To adjust the display
touch the ¨S¨ button and the or button at the same time until the display shows the actual height of the desk.
Changing between cm and inches:
Keep the S button pressed for approx. 5 sec. and the reading will change from the current setting.
The default setting depends on the type chosen. Switching between cm and inch can also be done via the DPF1C configurator.
Operation of the DPT
Desk up
Desk down
Store memory
Memory 1
Memory 2
Memory 3
S
1
2
3
To Next Page
Loading...
Need help?
General
