EasyManua.ls Logo

Linak JUMBO BAJ

Default Icon
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
JUMBO
TM
| 37
Mounting
Do not mount the battery upside down.
Please follow the mounting instructions of the control box e.g. CBJ Care or COBO.
Standby mode
When the BAJL is not being used for a longer period - more than a week - or when it is on stock, it enters
into a standby mode to save power and protect the battery from deep discharge.
Please connect the charger for approx. 15 seconds to exit the standby mode before use.
There is no audio signal to indicate the standby mode or to indicate exit of standby mode.
After exit of the standby mode
If there is still no power on, the battery needs to be charged. After charging, the hand control and/or the
control box will indicate the battery capacity level again.
Deep discharge protection
The BAJL has a deep discharge protection to extend the battery life.
The deep discharge protection is activated when the battery is discharged.
Please connect the charger for approx. 15 seconds to exit the deep discharge mode before use.
If the battery is completely discharged, the charging will be started at a very small rate to protect the
battery. This small charging rate is not sufficient to turn on the light in the charger, and therefore the user
may believe that the system has not yet started.
Depending on the battery state, it may take several hours to get to the normal charging state. The orange
light of the control box will not be turned on as the operation is analogue. It is therefore not possible to
see that the charging has started, however, only at a low level.
If any and all of the lithium ion batteries built into LINAK products are found to be defective under
warranty, LINAK will provide a new product to the OEM. LINAK explicitly disclaims all other remedies.
LINAK shall not in any event be liable under any circumstances for any special indirect punitive incidental or
consequential damages or losses arising from any incident related to the inherent risk of thermal runaway
in the lithium ion cell and any use of LINAK products. Moreover, LINAK explicitly disclaims lost profits,
failure to realise expected savings, any claim against our customer by a third party, or any other commercial
or economic losses of any kind, even if LINAK has been advised of the possibility of such damages or losses.
Transportation
The lithium ion batteries must be packed and transported according to applicable regulations. Always ask
your local transportation provider how to handle the transportation of lithium ion batteries.
Lithium ion batteries that are considered defective for safety reasons have been damaged or have the
potential of producing excessive heat or fire are not allowed for air transportation and must be disposed of
locally.