What to do if Lince 1906-BOBBY-T-E give false alarms?
If your Lince Security Sensors are triggering false alarms, consider these potential causes and solutions: * Check if the detector is perpendicular to the ground. If the lower detection area is wider than planned, it may cause false alarms. * Ensure there are no moving objects within the detection area.
How to fix continuous alarms of MASK output in Lince 1906-BOBBY-T-E?
If your Lince Security Sensors are experiencing continuous MASK output alarms, it might be due to medium-sized obstacles near the detector or the mask inside the cover is not properly positioned. To resolve this: * Open the lid, disconnect the detector (wait about 5 seconds), re-power it, and immediately close the lid (within 10 seconds). * Then, move out of range for 4 minutes. * Also, verify the position of the mask inside the cover.
Why is the red LED blinking on my Lince 1906-BOBBY-T-E Security Sensors?
If the red LED is blinking on your Lince Security Sensors, verify that the detector’s power supply is not below 10 Vdc.
How to troubleshoot Lince Security Sensors when LEDs fail to switch on?
If the LEDs on your Lince Security Sensors fail to switch on, try the following: 1. Check the wiring connection. 2. Ensure there is current and that the voltage is between 9.5 and 16 Vdc. 3. Make sure that Dip Switch 6 is set to OFF.
General| Detection Range | 12 meters |
|---|---|
| Detection Angle | 90 degrees |
| Power Supply | 12V DC |
| Protection Rating | IP65 |
| Output Type | Relay |
To Next Page