What to do if my Lincoln Electric Welding System displays the message E25 -C?
If the Lincoln Electric Welding System displays the message E25 -C, it indicates that the power source is overheating. Allow the generator to cool down. The fault should disappear automatically after a few minutes. Also, ensure that the inverter fan is functioning correctly.
What causes the E65-Mot error on a Lincoln Electric Welding System and how to fix it?
If the Lincoln Electric Welding System displays the message E65-Mot, there may be defective connectors, a mechanical problem, or a power supply issue. Check the connection of the encoder ribbon cable to the wire feeder's motor. Ensure that the wire feeder assembly is not blocked. Check the connection of the motor's power supply and check F2 (6A) on the auxiliary power card.
Why does my Lincoln Electric Welding System display the message E07 400?
If the Lincoln Electric Welding System displays the message E07 400, it means the main voltage is inappropriate. Ensure that the main voltage is within the +/- 20% acceptable range of the primary power supply of the power source.
What does error E63 IMO mean on my Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E63 IMO, there is a mechanical problem. The pressure roller might be too tight, the wire feed hose could be clogged with dirt, or the lock of the wire feed spool axle is too tight.
What does E50 H2o mean on my Lincoln Electric Welding System and how do I fix it?
If the Lincoln Electric Welding System displays the message E50 H2o, the cooler unit is in default. Make sure that the cooler unit is well plugged. Check the cooler unit (transformer, water pump, etc.). If no cooler unit is used, deactivate the parameter in the system.
What does E01-ond error mean on Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E01-ond, the maximum striking current of the power source was exceeded. Press the OK button to clear the fault. If the problem persists, call customer support.
What does error E24 SEn mean on a Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E24 SEn, it indicates a temperature sensor fault. Make sure that connector B9 is properly connected to the cycle card (if not, temperature measurement is not performed). If the problem persists, call customer support because the temperature sensor is out of order.
What does error E02 inu mean on a Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E02 inu, it indicates poor recognition of the power source, usually at start-up, and may be due to faulty connectors. Ensure that the ribbon cable between the inverter's main card and the cycle card is properly connected.
What does E33- MEM-LIM mean on my Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E33- MEM-LIM, it indicates that the memory is no longer operational due to malfunctioning during saving of memory. Call customer service.
What does error E43 brd mean on a Lincoln Electric Welding System?
If the Lincoln Electric Welding System displays the message E43 brd, it indicates that the electronic board is in default. Call customer service.
Overview of the welding set, its parts, and initial setup.
Details the purpose and operation of controls on the front panel.
Step-by-step guide for calibrating the power source for optimal welding.
Explains synergistic, manual, and setup configurations for welding.
General| Brand | Lincoln Electric |
|---|---|
| Model | SPEEDTEC 320CP |
| Category | Welding System |
| Language | English |
To Next Page