Contents
Safety ......................... 2
Explanation of signal words for safety . . 2
Inspection ....................... 3
Damaged pumps ................. 3
Description ..................... 3
General description ............... 3
Appropriate use .................. 3
Pump performance and
Specifications
................... 3
Installing the pump. . . . . . . . . . . . . . . 5
Operation ...................... 6
Setting the pump manifold and
flow controls
.................... 6
Crankcase oil service interval
recommendations
................ 6
Dimensions ..................... 7
Troubleshooting ................. 8
Tools required for maintenance
repair and adjustment
............ 9
Maintenance and repair ........... 9
Exploded view ................... 21
Repair parts .................... 24
Warranty ....................... 27
Explanation of signal words
for safety
Safety
Read and carefully observe these installation
instructions before installing/operating/
troubleshooting the assembly. The assembly
must be installed, maintained and repaired
exclusively by persons familiar with the
instructions.
Install the assembly only after safety in-
structions and this guide have been read
and are completely understood.
Adequate personal protection must be
used to prevent splashing of material on the
skin or in the eyes.
Always disconnect power source (elec-
tricity, air or hydraulic) from the pump when
it is not being used.
This equipment generates very high
grease pressure. Extreme caution should be
used when operating this equipment as ma-
terial leaks from loose or ruptured compo-
nents can inject fluid through the skin and
into the body. If any fluid appears to pene-
trate the skin, seek attention from a doctor
immediately.
Do not treat injury as a simple cut. Tell at-
tending doctor exactly what type of fluid was
injected.
Any other use not in accordance with
instructions will result in loss of claim for
warranty or liability.
• Do not misuse, over-pressurize, modify
parts, use incompatible chemicals, fluids,
or use worn and/or damaged parts.
• Do not exceed the stated maximum
working pressure of the pump or of the
lowest rated component in your system.
• Always read and follow the fluid manufac-
turer’s recommendations regarding fluid
compatibility, and the use of protective
clothing and equipment.
• Failure to comply may result in personal
injury and/or damage to equipment.
Indicates a hazardous situation which,
if not avoided, could result in minor or
moderate injury.
CAUTION
Indicates a hazardous situation which,
if not avoided will result in death or
serious injury.
WARNING
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
DANGER
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
SAFETY INSTRUCTIONS
This is the safety alert symbol. It is used
to alert you to potential physical injury
hazards. Obey all safety messages that
follow this symbol to avoid possible
injury or death.
2
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
To Next Page
Loading...
Need help?
General
