Lindo LVD01 - Mount the Doorbell on Surfaces Made Out of Hard Materials

7.3 Mount the Doorbell on Surfaces Made Out of
Hard Materials
1. If you’re mounting the doorbell on a surface made out of hard
materials, like brick, concrete, stucco, drill 2 holes through the screw
hold positioning card with a 15/64”(6mm) drill bit.
2. Insert the provided anchors, and then use the provided long screws
to secure the mounting bracket on the wall.
Screw Packs
Mounting BracketPower Drill
(not provided)
15/64”(6 mm)
Drill Bit
15° Mounting Wedge
(Optional)
What you need: Power Drill, 15/64” (6 mm) Drill Bit, Mounting Bracket,
15° Mounting Wedge (Optional), Screw Packs
22