12
Pedal Edit Mode
Most blocks can be edited without taking your hands o the guitar; if you hate having
to reach down and twist knobs, Pedal Edit mode will be your new best friend. Although
Pedal Edit is not intended to replace proper controller assignment, in a pinch, it can
also be used to tweak one parameter at a time during a performance.
1. Hold FS6 (MODE) for two seconds.
The preset's processing blocks appear on the footswitches, ashing:
A/BWhoWatt 100Mystery FilterVolume Pedal
Minotaur
1x12 US Deluxe
Adriatic DelayFX Loop 1/2OctoverbUbiquitous Vibe
EXIT
H O L D T O S A V E + E X I T
MORE...
If the preset has more than ten processing blocks, you may not see the block you
want. Press FS6 (MORE...) one or more times until you do.
NOTE: Selecting a block in Pedal Edit mode has no correlation to any foot-
switch assignment it may have.
2. Press the footswitch displaying the block you want to edit.
The block's rst page of parameters appear at FS1—FS6.
Mod Speed Mod DepthFeedbackTime Mod Phas
If the block has more than one page of parameters, press FS8 (<PAGE) or FS9
(PAGE>) until you nd the parameter.
3. Press the footswitch displaying the parameter you want to ad-
just.
4. Use the expression pedal to adjust the parameter.
For ne adjustment, press FS10 (VALUE–) and FS11 (VALUE+).
To select a dierent block, press FS7 (BACK).
5. When nished, press FS12 (EXIT).
If you want to save any changes made while in Pedal Edit mode, hold FS12 (EXIT)
for two seconds.
To Next Page
Loading...
Need help?
General
