Preparing to Install
233190 X3 Linear LLC 7 May 2013
Installation Overview Checklist
The major steps required for installing an eMerge system are as follows:
Review the information in this section to prepare for the installation.
Mount the cabinet (page 8).
Install any required additional blades (page 9).
Connect readers, inputs, outputs, and temperature sensors (page 12).
Wire the network connection (page 26).
Connect the system to a power source (page 12).
Add a backup battery (page 29).
Set up a small configuration network, if necessary (page 30).
This checklist presents a logical sequence for completing the installation.
Although it is not necessary to perform the steps in exactly this order, everything
should be plugged in BEFORE powering the unit.
CAUTION: Observe static electricity precautions when handling and
installing system components. These components can be damaged
by static discharge.
eMerge Part Numbers
Network Node Blade 0-587009
Access Control Blade 0-580100-L
Input Blade 0-580110
Output Blade 0-580120
Temperature Blade 0-580130
eMerge50P 230219P
eMerge5000P 230220P
Expansion Node 0-587004
To Next Page
Loading...