Connecting Readers, Inputs, Outputs, and Temperature Sensors
233190 X3 Linear LLC 16 May 2013
Input blades have eight male, 2-pin input connectors mounted on the blade, as
shown in Figure 10.
Figure 10. Input connectors mounted on the input blade.
Input blades and temperature blades look very much alike. To tell them apart,
look at the bar code sticker on the back of the blade. The numerals on the bar
code sticker for an input blade begin with “01,” as shown above The numerals on
the bar code sticker for a temperature blade begin with “08.”
If more inputs are required beyond the four provided on the access control blade
or the eight provided on the input blade, additional access or input blades can be
installed in the cabinet. For instructions, see “Installing Additional Blades” on
page 9.
Input Supervision Types
Note: The system supports the use of 1k Ohm resistors only.
Dual Resistor Input Circuits
Figure 11. Normally open and normally closed dual resistor input circuit.
To Next Page
Loading...