233190 X3 Linear LLC 26 May 2013
Wiring the Network Connection
To wire the network connection:
1. Pull the Ethernet cable through a knockout in the cabinet.
Cable specification: CAT 5 or better with an RJ-45 connector wired straight
through connecting to a network hub, switch, or router.
2. Plug the RJ-45 connector into the network switch port on the SAM-E module
mounted in the upper left side of the cabinet.
If the network connection is functioning properly, the Amber LED on the
network switch will light.
Figure 21. The SAM-E module
To Next Page
Loading...