LinearX LT360 - Chapter 2: Mounting; Rubber Feet

LT360 Precision Turntable
User Manual
LT360 Precision Turntable
User Manual
15
2.1 Rubber Feet
A package of 8 rubber foot pads are provided with the LT360. Depending
on how you intend to mount the LT360, you may or may not wish to use
the optional pads.
If you intend to bolt the LT360 directly to other rigging or fixtures, it is
probably best not to use the feet. This will allow you to bolt the base of the
LT360 directly to your fixture without the rubber pads between the inter-
face. This will make the joint more rigid.
If you will be using the
LT360 on the floor, then
the rubber feet can be
applied to the bottom of
the unit.
Turn the LT360 upside
down. Each of the
rubber pads has an
adhesive backing. Peel
the backing paper off,
and then apply the eight
pads as shown here.
Note that each of the
pads has holes which
align with those of the
bottom of the LT360.
74
LT360 ANALOG OUTPUT MODES
OUTPUT VOLTAGE
PLATTER MOVEMENT
START
MODE
STOP
MODE
CONT
MODE