LinearX LT360 - Page 20

LT360 Precision Turntable
User Manual
LT360 Precision Turntable
User Manual
20 69
■ Information
This group box displays the serial number and dates of the
LT360 unit. In normal use the factory calibration will probably
be adequate for continued use. If you have an application
requiring periodic recalibration for NIST compliance, the unit
can be recalibrated by sending it back to the factory.
■ Name
This is an arbitrary name which the user can
assign to a particular LT360 unit. For example:
Horz, Vert, etc. To change the name, click on
the button to the right of the field.
An edit dialog will be pre-
sented to change the name.
The name can be a maximum
of 21 characters.
The default name set by the
factory is SN with the serial
number appended.