LineEye LE Series - 3.4 Frame End Setting

26
Measurable Interface Expansion
By using the option for measurement expansion, you can expand the
communication target to be measured.
ڦ Exchange the board
Remove the standard interface sub board and replace it with the optional
interface sub board.
ڦ Loading and switching of extended 󳞛rmware
The rmwares for expansion options are available on the LINEEYE website.
Load it to the analyzer using le8rm.exe included in the attached CD. Once
written, the corresponding firmware starts up simply by replacing the sub-
board.

When using the optional high-speed firmware OP-FW10XR, you can switch between
standard rmware and high-speed rmware by turning on the power pressing [SHIFT] and [0]
or [SHIFT] and [3].
〇 In-vehicle communication
CAN FD / CXPI
Use OP-SB7XC.
〇 In-vehicle communication
CAN FD / LIN
Use OP-SB7XL.
〇 TTL communication with
synchronous clock
Use OP-SB5GL.