[POLAR DATA]
Select the 3. SEND POLAR DATA and press [ENT] to
view the FORMAT SELECTION screen.
Select DC1 format and press [ENT] to view the DATA SEND. CONFIRMATION screen.
(Same procedure is performed for AUX format.)
Press [ENT], and set the PC to be ready to receive.
4.3.3 Communication setup
The communication parameter is set when stored
data is received or sent between the instrument and
the PC etc.
4.3.3.1 Receiving data setting
Select the 4. COMMUNICATION SETUP and press
[ENT] to view the COMM. SETTING
SELECTION.
[1. RECEIVE RECT. DATA]
Select the 1. RECEIVE RECT. DATA and press
[ENT] to view the following screen.
Press [ENT] to open the selection window. Select
each setting and press [ENT].
32
To Next Page
Loading...
