To Next PageTo Next Page
Need help?Do you have a question about the Linhai ATV 150 B-type and is the answer not in the manual?
General| Brand | Linhai |
|---|---|
| Model | ATV 150 B-type |
| Category | Offroad Vehicle |
| Language | English |
Schedule and procedures for regular maintenance tasks to ensure safe and reliable vehicle operation.
Checks recommended for maintaining the braking system in good operating condition, including fluid levels and pad wear.
Detailed specifications and limits for engine components like cylinder head, bore, camshaft, and valves.
Procedures for inspecting and servicing engine parts including valve clearance, idle speed, and compression.
Procedures for cylinder and piston removal, inspection, and installation, including measurements and clearances.
Procedures for crankcase and crankshaft removal, inspection, and installation, including measurements.
Covers scheduled maintenance tasks like air filter replacement, spark plug checks, and valve adjustments.
Procedures for cylinder head and valve inspection, disassembly, and assembly, including specifications.
Detailed guide on cylinder and piston inspection, removal, and assembly, including measurements.
Instructions related to crankshaft and crankcase dismantling and assembly, including important points.
General information, troubleshooting, disassembly, and assembly procedures for the carburetor.
Procedures for periodic inspection and adjustment of air filter, spark plug, valve clearance, and carburetor idle.
Detailed steps for engine removal and installation, covering cylinder head, piston, and transmission.
Procedure for removing and inspecting the front drive axle, including CV joints and rubber boots.
Steps for installing the front drive axle, including CAUTIONary notes for differential oil seal protection.
Detailed disassembly and inspection of the inner CV joint and bearing assembly.
Procedure for assembling the front drive axle, including boot band placement and bearing greasing.
Procedure for testing the front gearcase slip limit torque, crucial for differential preload and steering effort.
Steps for removing the engine and transmission assembly, including disconnecting various components.
Procedure for installing the engine and transmission into the frame, aligning shafts and tightening fasteners.
Steps for disassembling the transmission, including removing cover bolts, bearings, and shafts.
Instructions for assembling the transmission, including installing shafts, gears, and covers.
Checklist for diagnosing shifting difficulties or transmission lock-up issues.
Step-by-step guide for replacing brake fluid and bleeding the brake system to remove air.
Steps for removing, inspecting, and installing front brake pads, including measuring friction material thickness.
Procedure for removing, inspecting, and installing rear brake pads, including friction material thickness measurement.
Information on battery inspection, removal, installation, charging, and testing procedures.
Troubleshooting guide for ignition system issues like no spark, weak spark, or intermittent spark.
Troubleshooting guide for starter motor failures, including checks for fuse, battery, and starter relay.
Comprehensive wiring diagrams for various ATV models and configurations.
