EasyManua.ls Logo

Linhai LH40DA - Charge Status Indicator; Optional Equipment Battery Upgrade; Battery Handling Precautions

Linhai LH40DA
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LH40DA OWNER’S/OPERATOR’S MANUAL 18.0
11. BATTERY
11-4
table below.
Color Indication Code Definition
Green Slow Flash Charge is complete,
Yellow Slow Flash 70%~90%
Red Slow Flash Less than 70%
CAUTION
Your ATV is equipped with a 100Ah Battery. This may no be sufficient
to provide power for optional equipment. When installing optional
equipment please upgrade your battery as necessary. See your dealer
for the proper battery.
FEATURES AND CONTROLS
Batteries
This vehicle is equipped with five 12-volt batteries that supply the power
needed to operate the vehicle. The batteries are located under the seat.
Always observe all battery safety warnings and safe handling
procedures as outlined on vehicle safety labels and in this manual.
Battery Handling Precautions
Always keep battery terminals and connections clean and free of
corrosion at all times.
Always maintain a full charge on the batteries. For best battery life,
avoid discharging the batteries more than 80%.
Make sure new batteries are fully charged before using.
New deep cycle batteries need to be cycled several times before
reaching full capacity (50- 125 cycles, depending on type). Capacity will
be limited during this time.
Make sure vent caps are installed properly and securely during
vehicle operation and battery charging.
Recharge batteries fully at the end of each day the vehicle is
operated, allowing adequate time for the charger to complete its charge
cycle. The batteries in this vehicle do not have a “memory effect”.
Frequent charging will extend their life.

Related product manuals