Linksys LAPAC1200C User Manual

107
To perform the firmware upgrade from TFTP server:
1. Enter the IP address of the TFTP server and the source file. The source file is the firmware
filename you stored in your TFTP server. Only IPv4 addresses are supported.
2. Click Upgrade.
To perform a firmware upgrade from the Internet:
1. Click Check for Upgrade to see if there is new firmware available.
2. Click the OK on the popup dialogue box to start the firmware download and upgrade if a
new version of firmware is available.
Configuration Backup/Restore
Go to Maintenance > Maintenance > Configuration Backup/Restore to download the
configuration file from the device. You can save it to external storage, e.g., your PC, or network
storage. You can also upload a previously saved configuration file from external storage to the
device. It is highly recommended you save one extra copy of the configuration file to external
storage after you are done with access point setup.

Linksys LAPAC1200C Specifications

General

Color	multi, white
Wi-Fi Speed	1200 gigabits per second
Wireless Standard	ac, n
Data Encryption	yes
Encryption Type	other, wep, wpa, wpa2
Security Features	802.1x supplicant; mac-based acl; rogue ap detection; ssid-to-vlan mapping
Ports	other, rj-45
Bluetooth	no

Weight and Dimensions

Height	1.72 inches
Width	9.33 inches
Net Weight	1.12 pounds