EasyManuals Logo

Linksys PAP2 Installation Guide

Linksys PAP2
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Linksys PAP2 Installation Guide
Page 1
1 Introduction
This document is an installation/configuration guide for the Linksys PAP2 phone adapter
running firmware version 2.0.10 (LSc). It describes how to configure the SIP parameters,
codec settings and analog coefficients for outbound calling. It also includes steps for
provisioning the device with the user account and PIN. Once you complete these steps,
you will be ready to begin placing calls.

Table of Contents

Other manuals for Linksys PAP2

Preview: User Manual
User Manual17 pages
Preview: Configuration Guide
Configuration Guide9 pages
Preview: Instructions For Setting Up
Instructions For Setting Up7 pages
Preview: Configuration Manual
Configuration Manual9 pages
Preview: Quick Start Guide
Quick Start Guide3 pages
Preview: Quick Installation
Quick Installation1 page
Preview: User Guide
User Guide4 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys PAP2 and is the answer not in the manual?

Linksys PAP2 Specifications

General IconGeneral
Ports2 FXS ports
Protocol SupportSIP v2, SDP
Voice CodecsG.711, G.726, G.729A/B, G.723.1
Network ProtocolsTCP/IP, UDP, DHCP, DNS, TFTP, HTTP
SecurityPassword protected system reset
Connectivity10/100 Mbps Ethernet
Power Supply5V DC

Related product manuals