Linksys PAP2 Installation Guide
Page 3
PAP2 MENU OPTIONS
Action Code User Input Behavior Notes
Enter IVR Menu **** None Do not press any other keys
until you hear, “Configuration
menu. Please enter option
followed by the pound (#)
key, or hang up to exit.”
Check DHCP 100 None The system announces if
DHCP is enabled or disabled.
Set DHCP 101 Enter 1 to enable.
Enter 0 to disable.
Enter the option, followed by
the pound (#) key.
Check IP
address
110 None
Set IP Address 111 Enter value using the
numbers on the
telephone keypad. Use
the star (*) key when
entering a decimal point.
Enter the value, followed by
the pound (#) key. DHCP
must be “Disabled,”
otherwise you will hear the
announcement, “Invalid
Option” if you try to set this
value.
Check Net Mask 120 None
Set Net Mask 121 Enter value using the
numbers on the
telephone keypad. Use
the star (*) key when
entering a decimal point.
Enter the value, followed by
the pound (#) key. DHCP
must be “Disabled,”
otherwise you will hear the
announcement, “Invalid
Option” if you try to set this
value.
Check Gateway 130 None
Set Gateway 131 Enter the value using the
numbers on the
telephone keypad. Use
the star (*) key when
entering a decimal point.
Enter the value, followed by
the pound (#) key. DHCP
must be “Disabled,”
otherwise you will hear the
announcement, “Invalid
Option” if you try to set this
value.
Check MAC
Address
140 None You will hear the phone
adapter’s MAC address.
Check Firmware
Version
150 None You will hear the phone
adapter’s firmware version.
Manual Reboot 7326668 None After you hear, “Option
successful,” hang up the
phone. The phone adapter
will automatically reboot.
PAP2 Menu Options
To Next Page
Loading...
Need help?
General
