Accessing the Linksys RE9000’s web-based setup page
The Linksys RE9000 MU-MIMO Range Extender is a tri-band ethernet bridge and a range
extender all-in-one. This article will show you how you can access the Linksys RE9000’s web-based
setup page.
Step 1:
Connect a device to your range extender’s Wi-Fi and launch a browser once connected.
Step 2:
Do one of the following methods to log in to the Linksys RE9000’s web-based setup page:
Enter "http://extender.linksys.com” in the Address bar.
Enter “http://RE9000” (for Windows® users) in the Address bar
NOTE: If you changed your Linksys RE9000’s name, then you will need to use the custom name
(e.g., http://MyAP).
Enter "http://RE9000.local" (for Mac® users) in the Address bar.
NOTE: If you changed your Linksys RE9000 name, then you will need to use the custom name
(e.g., http://MyAP.local).
Enter the Linksys RE9000’s IP address.
NOTE: If the Linksys RE9000 does not detect a DHCP server, the default IP address
is 192.168.1.1. Otherwise, you will need to look up your range extender’s IP address in the DHCP
table. To know how to do this using a Linksys Wi-Fi Router, click here. If you are using a Linksys
Smart Wi-Fi Router, click here.
QUICK TIP: Some options may not be available in Access Point mode due to the design and
functionality as an access point.
Step 3:
You will be prompted for an administrative Password. If you have changed your password, enter
your customized password. Otherwise, enter the default “admin” in the field then click Login.
To Next Page
Loading...
Need help?
General
