Chapter 3
Advanced Configuration
15
Wireless-G Broadband Router with 2 Phone Ports
“Wi-Fi Protected Setup” section. To manually configure
your wireless network, select Manual. Proceed to the
“Wireless Network” section.
NOTE: Wi-Fi Protected Setup is available
for your primary wireless network
(SSID1) only. To configure your second
wireless network (SSID2), select Manual.
If you are unable to configure the second wireless
network, contact your service provider for more
information (these settings may be controlled by
your service provider).
Wi-Fi Protected Setup
There are three methods available. Use the method that
applies to the client device you are configuring.
Wireless > Basic Wireless Settings (Wi-Fi Protected Setup)
Wi-Fi Protected Setup > Congratulations
NOTE: Wi-Fi Protected Setup configures one
client device at a time. Repeat the instructions
for each client device that supports Wi-Fi
Protected Setup.
Method #1
Use this method if your client device has a Wi-Fi Protected
Setup button.
Click or press the1. Wi-Fi Protected Setup button on
the client device.
Click the 2. Wi-Fi Protected Setup button on this
screen.
After the client device has been configured, click 3.
OK. Then refer back to your client device or its
documentation for further instructions.
Method #2
Use this method if your client device has a Wi-Fi Protected
Setup PIN number.
Enter the PIN number in the1. field on this screen.
Click 2. Register.
After the client device has been configured, click 3.
OK. Then refer back to your client device or its
documentation for further instructions.
Method #3
Use this method if your client device asks for the Router’s
PIN number.
To Next Page
Loading...
