Chapter 3
Advanced Configuration
18
Wireless-G Broadband Router with 2 Phone Ports
Security Mode > WPA2 Enterprise
WPA Algorithms WPA2 supports two encryption
methods, TKIP and AES, with dynamic encryption keys.
Select the type of algorithm, AES or TKIP + AES. The
default is TKIP + AES.
RADIUS Server Address Enter the IP address of the
RADIUS server.
RADIUS Port Enter the port number of the RADIUS
server. The default value is 1812.
Shared Key Enter the key shared between the Router
and the server.
Key Renewal Timeout Enter a Key Renewal Timeout
period, which instructs the Router how often it should
change the encryption keys. The default is 3600 seconds.
WEP
WEP is a basic encryption method, which is not as secure
as WPA.
Security Mode > WEP
Encryption Select a level of WEP encryption, 64 bits 10
hex digits or 128 bits 26 hex digits. The default is 64 bits
10 hex digits.
Passphrase Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 1-4 If you did not enter a Passphrase, enter the WEP
key(s) manually.
TX Key Select which TX (Transmit) Key to use. The default
is 1.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
Wireless > Wireless MAC Filter
Wireless access can be filtered by using the MAC addresses of
the wireless devices transmitting within your network’s radius.
Wireless > Wireless MAC Filter
Wireless MAC Filter
Select a SSID Select the appropriate SSID. (If you enabled
the second wireless network on the Basic Wireless Settings
screen, then set up wireless MAC filtering for each SSID.)
Wireless MAC Filter
To filter wireless users by MAC address,
either permitting or blocking access, select Enabled. If you
do not wish to filter users by MAC address, keep the default
setting, Disabled
.
Access Restriction
Prevent Select this to block wireless access by MAC
address. This button is selected by default.
Permit Select this to allow wireless access by MAC
address. This button is not selected by default.
To Next Page
Loading...
