Chapter 3
Advanced Configuration
29
Wireless-G Broadband Router with 2 Phone Ports
Diagnostics > Traceroute
Detect Active LAN Client(s)
Search Time Select how many seconds you wish to
perform this search: 5, 10, or 15.
Start to Search To run the search, click this button. The
Active LAN Client Table screen will show the search results.
You can sort the results by IP Address, MAC Address,
Interface, Client Name, or IP Status.
To re-run the search, click Retry. Click Close to return to
the Diagnostics screen.
Diagnostics > Active LAN Client Table
Administration > Factory Defaults
The Administration > Factory Defaults screen allows
you to restore the Router’s configuration to its Router
and/or voice factory default settings.
Administration > Factory Defaults
NOTE: Restoring factory defaults deletes custom
settings. Note your custom settings before
restoring the factory defaults.
Factory Defaults
Restore Router Factory Defaults To reset the Router
settings to the default values, select Yes. Then click Save
Settings. Any custom Router settings you have saved will
be lost when the default settings are restored.
Restore Voice Factory Defaults To reset the voice
settings to the default values, select Yes. Then click Save
Settings. Any custom Voice settings you have saved will
be lost when the default settings are restored.
NOTE: Restoring the voice defaults may require
your login (the default user name and password
are admin). If the defaults do not work, contact
your service provider for more information.
On the Factory Defaults screen, click Save Settings to
apply your changes, or click Cancel Changes to cancel
your changes.
Administration > Firmware Upgrade
The Firmware Upgrade screen allows you to upgrade the
Router’s firmware. Do not upgrade the firmware unless
you are experiencing problems with the Router or the new
firmware has a feature you want to use.
If you want to upgrade the Router’s firmware,
then you may
need a user name and password available only from your
service provider. Contact your service provider for more
information.
Username & Password
If you see the Username & Password screen, enter the User
Name and Password provided by your service provider.
(The factory default User Name and Password are admin.)
Then click OK.
To Next Page
Loading...
