Chapter 3
Advanced Configuration
33
Wireless-G Broadband Router with 2 Phone Ports
Elapsed Time The amount of time elapsed since the last
reboot of the Router is displayed.
RTP Packets Sent The number of RTP packets sent by the
Router is displayed.
RTP Bytes Sent The number of RTP bytes sent by the
Router is displayed.
RTP Packets Recv The number of RTP packets received
by the Router is displayed.
RTP Bytes Recv The number of RTP bytes received by the
Router is displayed.
SIP Messages Sent The number of SIP messages sent by
the Router is displayed.
SIP Bytes Sent The number of SIP bytes sent by the
Router is displayed.
SIP Messages Recv The number of SIP messages received
by the Router is displayed.
SIP Bytes Recv The number of SIP bytes received by the
Router is displayed.
External IP The external IP address used for NAT mapping
is displayed.
Line 1/2 Status
Lines 1 and 2 have the same status information available.
Hook State The status of the Internet phone line’s
readiness is displayed. “On” indicates that it is ready for
use, while “Off” indicates that it is in use.
Registration State The status of the line’s registration
with the service provider is displayed.
Last Registration At The last date and time the line was
registered are displayed.
Next Registration In The number of seconds until the
next registration is displayed.
Message Waiting This indicates whether you have new
voicemail waiting.
Call Back Active This indicates whether a call back
request is in progress.
Last Called Number The last number called is displayed.
Last Caller Number The number of the last caller is
displayed.
Mapped SIP Port The port number of the NAT mapped
SIP port is displayed.
Calls 1 and 2 have the same status information available.
Call 1/2 State The status of the call is displayed.
Call 1/2 Tone The type of tone used by the call is
displayed.
Call 1/2 Encoder The codec used for encoding is
displayed.
Call 1/2 Decoder The codec used for decoding is
displayed.
Call 1/2 FAX The status of the fax pass-through mode is
displayed.
Call 1/2 Type The direction of the call is displayed.
Call 1/2 Remote Hold This indicates whether the far end
has placed the call on hold.
Call 1/2 Callback This indicates whether the call was
triggered by a call back request.
Call 1/2 Peer Name The name of the internal phone is
displayed.
Call 1/2 Peer Phone The phone number of the internal
phone is displayed.
Call 1/2 Duration The duration of the call is displayed.
Call 1/2 Packets Sent The number of packets sent is
displayed.
Call 1/2 Packets Recv The number of packets received
is displayed.
Call 1/2 Bytes Sent The number of bytes sent is
displayed.
Call 1/2 Bytes Recv The number of bytes received is
displayed.
Call 1/2 Decode Latency The number of milliseconds for
decoder latency is displayed.
Call 1/2 Jitter The number of milliseconds for receiver
jitter is displayed.
Call 1/2 Round Trip Delay The number of milliseconds
for delay is displayed.
Call 1/2 Packets Lost The number of packets lost is
displayed.
Call 1/2 Packet Error The number of invalid packets
received is displayed.
Call 1/2 Mapped RTP Port The number of the NAT
mapped RTP port is displayed.
Call 1/2 Media Loopback The Media Loopback feature
allows the service provider to test the quality of the
connection to the Router. The status of the feature is
displayed.
To Next Page
Loading...
