12
Upgrades
NOTE: The antenna connection is already
built into your engine. The antenna in the
upgrade kit is not required.
T
his upgrade is made using kit 6-22960,
which includes a radio circuit and an
antenna. Remove the cab from the chassis as
described on page 8. First, unplug the 104E
unit circuit board by pulling it straight back
from its mounting pins and set it aside. Next,
plug the circuit board (R2LC) into the same
mounting pins that the 104E unit was
removed from.
Command Control Upgrade
104E Unit
R2LC
To Front of F3
To Next Page
Loading...
