15
TrainMaster Command operations
Running your F3 in the TrainMaster Command environment
Press AUX2 to turn your
F3’s headlight on and
off.
Activates keypad.
D
IESEL AIR-RELEASE
SOUND
.
Press HALT to shut down all Power-Master electrical out-
put on your railroad. Stops all Command-equipped
Lionels in operation.
Turn the THROTTLE to the
right to accelerate, left to
decelerate. Engine RPMs
will increase or decrease
with throttle settings.
address Locomotive #1
PowerMasters set to CMD or traditional
power supplies ON FULL
Press ENG
Press 1 (the ID#)
Throttle up/press any command button
Example
CAB-1 commands for your F3
Press WSTL/HRN to activate
the F3 horn, release it to dis-
continue. MULTIHORN DIESEL
HORN SOUND
.
Press DIR—the locomotive
decelerates to a complete stop;
turn the throttle up, and the
locomotive will accelerate in
the new, opposite direction.
T
HERE IS NO NEUTRAL STATE.
DIESEL AIR-RELEASE SOUND.
Press BELL once to activate the
bell, again to discontinue.
D
IESEL MECHANICAL BELL
SOUND
.
Press and hold BRAKE to slow
down or stop. Release BRAKE and
return to the previous speed.
Engine RPMs decrease once
stopped. RPMs will increase once
brake is released and train begins
moving. S
QUEALING BRAKE
SOUNDS
.
Non-powered F3A
unit rear coupler
releases. COUPLER
RELEASE SOUNDS
.
Powered F3A unit front
coupler releases.
C
OUPLER RELEASE
SOUNDS
.
Press and hold BOOST for
extra power. Release BOOST
and return to the F3’s previ-
ous speed.
Y
our Command upgrded F3 set
comes factory-programmed with
an ID# of “1.” To get your F3A set in
action, set PowerMasters to CMD or
set all power supplies on full. Press
ENG and “1” on CAB-1. Turn the
throttle or press any command but-
ton; your F3A set is ready for
Command operations.
Note!
Sounds other than horn and bell only if Railsounds upgrade installed . Coupler will
operate only if coil coupler upgrade is installed.
To Next Page
Loading...
