Lipper Ground Control 3.0 - Introduction and Safety; Introduction; Safety Precautions

Rev: 09.02.21 Page 2 CCD-0004395
TABLE OF CONTENTS
Introduction 2
Safety 2
Resources Required 3
Installation of Prep Kit 3
Switch Panel Installation 3
Wiring the Switch Panel and Landing Gear 5
Rear Sensor Harness 6
Middle and Rear Jack Harnesses 6
Operation 7
Prior to Operation 7
Operating Landing Gear 7
Troubleshooting 8
Manual Override 8
Wiring Diagram 10
Notes 11
Introduction
The Ground Control® 3.0 5th Wheel Landing Gear operates independently on uneven terrain. Raise and
lower the front of your RV quicker and easier than ever, with the push of a button. Power operation
eliminates the need for manual cranking. The 5th wheel landing gear system can be upgraded to a fully
automatic 6 -point leveling system.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/ground-control-3.0-touch-pad.
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage,
including voiding of the LCI limited warranty.
The trailer MUST be supported per manufacturer's specications before working underneath.
Failure to do so may result in death or serious injury.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause death
or serious personal injury if not performed safely and within the parameters set forth in this manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.