Rev: 08.18.20 Page 3 CCD-0003685
TI-353
SOLERA
®
POWER AWNING REGAL HEAD
SPEAKER REPLACEMENT
AWNINGS
Grill Cover
Foam Gasket
Speaker
Fig. 4
Speaker Wires
Tabs
Drive Head
4. With the grill cover (Fig. 3) removed, remove the rubber foam gasket from the top of the speaker (Fig. 4).
5. There is a small tab (Fig. 4) in each corner of the open cavity that the actual speaker sets in. Remove
the speaker and determine if there is enough slack in the wires to pull the speaker out far enough
to disconnect it from the main harness. If there is enough slack, remove the speaker and go to the
Installation section. If unable to disconnect the speaker wires from the main harness go to step 6.
To Next Page
Loading...
