Need help?Do you have a question about the Lippert Components In-Wall Slide-Out Winnebago and is the answer not in the manual?
General| Brand | Lippert Components |
|---|---|
| Model | In-Wall Slide-Out Winnebago |
| Category | Automobile Accessories |
| Language | English |
Measure gear racks for parallelism and C-Column squareness.
Measure clamp strap to slide room wall clearance.
Use the controller's override mode to move the slide room.
Disconnect motor harnesses to manually push the slide room.
Disengage motors to manually push the slide room.
Replace entire system if torque shaft is bowed, bent, or dropped.
Replace entire system if gibs are broken, loose, or missing rivets.
Replace system if metal shavings indicate spur gear wear on torque shaft.
Replace entire system if the C-column is damaged.
Steps to cut, deburr, and install new In-Wall gear racks.
Steps to snap a new shoe onto the bearing block foot.
Steps to remove snap ring, replace v-roller, and re-seat snap ring.
Steps to replace bearing blocks and spur gears.
Lists part numbers for Winnebago fixed and float repair packages.
Details the bearing block repair kit including contents and part number.
To Next Page