Lippert Cosmo 2 Euro - Securing the Cable with Stopper Nut

Rev: 08.31.23 Page 7 CCD-0007174
12. Hold or clamp the cable against the slide table bracket (Fig. 8A) while installing the stopper nut
(Fig.8B) onto the threaded stud. Use a hex wrench to tighten the stopper nut in-place.
NOTE: Pedestal not shown for clarity.
13. Release the cable. The cable should now rest between the slide table bracket and the stopper
nut(Fig.9A).
NOTE: Pedestal not shown for clarity.
14. Push the table slide handle (Fig. 9B) inward. The cable should rest against the cable tension lock
(Fig.9C) on the handle.
A
B
A
B
C
Fig. 8
Fig. 9