Lippert Cosmo 2 Euro - Finalizing Cable Tension and Locking; Attaching the Table Top

Rev: 08.31.23 Page 8 CCD-0007174
15. If necessary, adjust the table slide until it is centered with the pedestal.
16. Use a wrench to turn the cable tensioner (Fig. 10A) clockwise to restore full tension on the cable.
17. The table is now in its default, locked position.
18. Retrieve the OEM-supplied table top and place it squarely on the slide support.
19. Use a tape measure to make sure that the table top is centered on the slide support side rails (Fig. 11).
Dimensions A and B should be equal and dimensions C and D should be equal for each side (Fig. 11).
C
A
B
D
A
Fig. 10
Fig. 11