Lippert Ground Control 3.0 - Operation; Prior to Operation; Touch Pad Diagram

12
lippert.com 432-LIPPERT (432-547-7378) Rev: 10.14.21
Ground Control
®
3.0
5th Wheel Leveling Prepped Unit
to Full Automatic Leveling
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004397
Operation
Prior to Operation
BE SURE TO PARK THE TRAILER ON SOLID, LEVEL
GROUND. CLEAR ALL JACK LANDING LOCATIONS
OF DEBRIS AND OBSTRUCTIONS. LOCATIONS
SHOULD ALSO BE FREE OF DEPRESSIONS. WHEN
PARKING THE TRAILER ON EXTREMELY SOFT
SURFACES, UTILIZE LOAD DISTRIBUTION PADS
UNDER EACH JACK. PEOPLE AND PETS SHOULD
BE CLEAR OF THE TRAILER WHILE OPERATING
LEVELING SYSTEM. NEVER LIFT THE TRAILER
COMPLETELY OFF THE GROUND. LIFTING THE
TRAILER SO THE WHEELS ARE NOT TOUCHING THE
GROUND WILL CREATE AN UNSTABLE AND UNSAFE
CONDITION.
DO NOT EXCEED GVWR OR SEVERE DAMAGE TO
PRODUCT OR PROPERTY MAY OCCUR.
MOVING PARTS CAN PINCH, CRUSH OR CUT. KEEP
CLEAR AND USE CAUTION.
The leveling system should only be operated under the
following conditions:
1. The trailer is parked on a reasonably level surface.
2. Be sure all persons, pets, and property are clear of the
trailer while the leveling system is in operation.
3. Make sure battery(ies) are fully charged and test at
12+VDC under load.
Touch Pad Diagram
FAILURE TO ACT IN ACCORDANCE WITH THE
FOLLOWING MAY RESULT IN DEATH OR SERIOUS
PERSONAL INJURY. THE USE OF THE GROUND
CONTROL® 3.0 LEVELING SYSTEM TO SUPPORT
THE TRAILER FOR ANY REASON OTHER THAN
WHICH IT IS INTENDED IS PROHIBITED BY
LIPPERT’S LIMITED WARRANTY. THE LIPPERT
LEVELING SYSTEM IS DESIGNED AS A LEVELING
SYSTEM ONLY AND SHOULD NOT BE USED TO
PROVIDE SERVICE FOR ANY REASON UNDER THE
TRAILER SUCH AS CHANGING TIRES OR SERVICING
THE LEVELING SYSTEM. ANY ATTEMPTS TO
CHANGE TIRES OR PERFORM OTHER SERVICE
WHILE TRAILER IS SUPPORTED BY THE GROUND
CONTROL® 3.0 LEVELING SYSTEM COULD RESULT
IN DEATH, SERIOUS INJURY OR DAMAGE TO THE
5TH WHEEL.
Letter Description
A Up Arrow - Scrolls up through menu on LCD
B Down Arrow - Scrolls down through menu on LCD
C Enter - Activates modes and procedures on LCD
D
Retract - Places system into retract mode (Press
and hold down for 1 second to initiate Auto Retract)
E
LCD Display - Displays procedures and results
F Auto Level - Places system into auto level mode
G Front Button - Activates both front jacks
H Left Button - Activates left jack(s)
I Right Button - Activates right jack(s)
J Rear Button - Activates rear jacks
K Power Button - Turns system on and off
Fig.28
A
B
C
D
E
K
G
I
J
H
F