15
lippert.com 432-LIPPERT (432-547-7378) Rev: 10.14.21
Ground Control
®
3.0
5th Wheel Leveling Prepped Unit
to Full Automatic Leveling
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004397
Hitch Recognition
1. Turn on the touch pad.
NOTE: Auto Hitch feature can be activated by pressing
LEFT and RIGHT buttons simultaneously at this point or
using the steps outlined below.
2. Push the UP or DOWN arrow (Fig.33A) to scroll to, Auto
Hitch option on LCD screen.
NOTE: If the Auto Hitch function is not available the LCD
display will read AUTO HITCH UNAVAILABLE.
3. Push ENTER (Fig.33B). The rear jacks and middle jacks
trailer to the height where the auto level sequence was
started.
NOTE: If the auto level sequence was started with the
front of the trailer in a below-level condition, the Hitch
Recognition feature will retract the rear and middle jacks
first, and leave the front of the unit in the current position.
Troubleshooting
MAKE SURE THE TRAILER IS SUPPORTED AT
BOTH THE FRONT AND REAR WITH JACK STANDS
BEFORE PERFORMING ANY TROUBLESHOOTING
OR SERVICE TO THE TRAILER. FAILURE TO DO SO
MAY RESULT IN DEATH OR PERSONAL INJURY.
Manual Override
NOTE: For ease of manual override it is recommended to
unplug the power harness to the motor prior to performing
the manual override procedure.
NOTE: Use of a 12-18 volt cordless screw gun or
pneumatic screw gun is acceptable to manually override
the jacks. Do not use an impact screw gun to perform any
of the override procedures, as this may damage the motor.
If manual override is necessary there are two options.
Top of Jack Motor Override
Resources Required: 3/8” drive ratchet and extension
(no socket)
1. Find the port on the top of the jack motor (Fig.34A).
2. Remove the rubber plug (Fig.35A).
3. Insert the 3/8” drive into the port (Fig.36A).
4. Turn override until the jack extends or retracts to
desired position.
Fig.34
Fig.35
Fig.36
A
A
A
Fig.33
B
A
To Next Page
Loading...
