6
lippert.com 432-LIPPERT (432-547-7378) Rev: 10.14.21
Ground Control
®
3.0
5th Wheel Leveling Prepped Unit
to Full Automatic Leveling
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004397
Rear Sensor Installation
NOTE: The rear sensor (Fig.7) MUST be installed on a
crossmember in line with or behind the rear jacks, centered
curbside to roadside on the trailer with the arrows on the
top of the sensor pointing in the correct direction (Fig.7A),
and in reach of OEM prepped harness.
Fig.7
A
1. (Fig.8B) and the rear sensor
(Fig.8C) to the crossmember (Fig.8A). The pre-drilled holes
in the plate are for mounting the rear sensor to the plate.
Mark on the plate where the rear sensor will set. Space
between the sensor and the crossmember MUST be left so
the wire harness will not be pinched.
3. Pull the rear sensor harness connection (Fig.10A) end out
from the slit in the underbelly of the trailer (Fig.10B). Make
sure the rear sensor harness connection will reach the
location of the rear sensor installation from step 1.
Fig.8
2. Underneath near the back of the trailer, locate the rear
sensor harness (Fig.9A), sticking out from the underbelly
of the trailer.
Fig.9
Front
Rear
A
B
C
B
Fig.10
A
A
To Next Page
Loading...
