14
lippert.com 432-LIPPERT (432-547-7378) Rev: 10.14.21
Ground Control
®
3.0
5th Wheel Leveling Prepped Unit
to Full Automatic Leveling
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004397
Auto Level
1. After unhitching from tow vehicle and parking the tow
vehicle at a safe distance away from the trailer, press the
“ON/OFF” button (Fig.28K) and then press “AUTO LEVEL”
(Fig.28F).
NOTE: Once the automatic leveling cycle has been
started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process.
Failure to remain still during the leveling cycle could have
an effect on the performance of the leveling system.
Auto Level Sequence
1. When Auto Level Sequence begins, the controller will
verify that the front landing gear are contacting the ground.
2. The control will then bring the front of the coach to a
point near level from front to back.
3. The rear jacks will then be extended until ground contact
is made.
4. A side to side leveling sequence will occur.
5. The LCD display will read, AUTO LEVEL SUCCESS
(Fig.31)
Fig.31
Fig.32
B
6. The controller will then extend the middle jacks until
ground contact is made to assist in stabilizing the unit.
7.
that each leveling jack is contacting the ground. When
battery voltage will be displayed (Fig.32).
NOTE: If the AUTO LEVEL sequence does not perform as
described, place the system in manual mode and test that
the jacks operate correctly by pushing their coordinating
buttons on the touch pad; i.e., FRONT button operates
only the front jacks, etc.
4. Push the “FRONT” button (Fig.30D) extending the front
5. Pull tow vehicle away and park at a safe distance.
To Next Page
Loading...
